Difference between revisions of "Nokia IP330"
From coreboot
(→Development status) |
|||
| Line 25: | Line 25: | ||
The current development status is; No coreboot running yet | The current development status is; No coreboot running yet | ||
| + | |||
| + | |||
| + | |||
| + | == Hardware status == | ||
| + | |||
| + | {{Status| | ||
| + | |||
| + | |CPU_status = OK | ||
| + | |CPU_comments = PIII SL5DV (1000 / 256 / 133 / 1.75V) | ||
| + | |CPU_L1_status = OK | ||
| + | |CPU_L1_comments = CPU: L1 I cache: 16K, L1 D cache: 16K | ||
| + | |CPU_L2_status = OK | ||
| + | |CPU_L2_comments = L2 cache is standard for the P3-68X models | ||
| + | |CPU_L3_status = N/A | ||
| + | |CPU_multiple_status = N/A | ||
| + | |CPU_multicore_status = N/A | ||
| + | |CPU_virt_status = N/A | ||
| + | |||
| + | |RAM_EDO_status = N/A | ||
| + | |RAM_SDRAM_status = OK | ||
| + | |RAM_SDRAM_comments = upto 4 single sided 128Mb or 4 dual sided 256Mb | ||
| + | |RAM_SODIMM_status = N/A | ||
| + | |RAM_DDR_status = N/A | ||
| + | |RAM_DDR2_status = N/A | ||
| + | |RAM_DDR3_status = N/A | ||
| + | |RAM_dualchannel_status = N/A | ||
| + | |RAM_ecc_status = WIP | ||
| + | |RAM_ecc_comments = Not yet supported by the coreboot 440BX code, but it's on our TODO list. | ||
| + | |||
| + | |IDE_status = OK | ||
| + | |IDE_comments = Primary and secondary controllers, the primary controller has a Compact Flash slot attached on board, as primary drive. | ||
| + | |IDE_25_status = N/A | ||
| + | |SATA_status = N/A | ||
| + | |USB_status = OK | ||
| + | |USB_comments = The USB is not routed to any connector, u can be picked up from the board it self, there is an instruction below on this wiki-page how to do this | ||
| + | |Onboard_VGA_status = N/A | ||
| + | |Onboard_ethernet_status = OK | ||
| + | |Onboard_ethernet_comments = Four intel 21143PD controllers. | ||
| + | |Onboard_audio_status = N/A | ||
| + | |Onboard_modem_status = N/A | ||
| + | |Onboard_firewire_status = N/A | ||
| + | |Smartcard_status = N/A | ||
| + | |Onboard_CF_status = OK | ||
| + | |Onboard_CF_comments = Is wrired are primary drive on primary IDE controller. | ||
| + | |Onboard_PCMCIA_status = OK | ||
| + | |Onboard_PCMCIA_comments = Texas Instruments PCI1225 PCMCIA/Cardbus controller | ||
| + | |Onboard_SCSI_status = N/A | ||
| + | |||
| + | |ISA_cards_status = N/A | ||
| + | |AMR_cards_status = N/A | ||
| + | |Mini_PCI_cards_status = N/A | ||
| + | |PCIX_cards_status = N/A | ||
| + | |PCI_cards_status = OK | ||
| + | |PCI_cards_comments = Tested: With 4 Ethernet adapter card of Nokia (Compact-PCI slots) | ||
| + | |AGP_cards_status = N/A | ||
| + | |PCIE_cards_status = N/A | ||
| + | |PCIE_x1_status = N/A | ||
| + | |PCIE_x2_status = N/A | ||
| + | |PCIE_x4_status = N/A | ||
| + | |PCIE_x8_status = N/A | ||
| + | |PCIE_x16_status = N/A | ||
| + | |PCIE_x32_status = N/A | ||
| + | |HTX_status = N/A | ||
| + | |||
| + | |Floppy_status = N/A | ||
| + | |COM1_status = OK | ||
| + | |COM2_status = OK | ||
| + | |PP_status = N/A | ||
| + | |PS2_keyboard_status = OK | ||
| + | |PS2_keyboard_comments = Internal 4 pin connector J-KBD | ||
| + | |PS2_mouse_status = N/A | ||
| + | |Game_port_status = N/A | ||
| + | |IR_status = N/A | ||
| + | |Speaker_status = N/A | ||
| + | |DiskOnChip_status = N/A | ||
| + | |||
| + | |Sensors_status = WIP | ||
| + | |Watchdog_status = N/A | ||
| + | |CAN_bus_status = N/A | ||
| + | |CPUfreq_status = N/A | ||
| + | |Powersave_status = N/A | ||
| + | |ACPI_status = No | ||
| + | |ACPI_comments = There's no ACPI implementation for this board, but it's on our TODO list. | ||
| + | |SMBus_status = WIP | ||
| + | |Reboot_status = N/A | ||
| + | |Poweroff_status = N/A | ||
| + | |LEDs_status = OK | ||
| + | |LEDs_comments = Special-purpose LEDs available on the board, '''Alert''' and '''Fault''' are controlled by the superio | ||
| + | |HPET_status = N/A | ||
| + | |RNG_status = N/A | ||
| + | |WakeOnModem_status = N/A | ||
| + | |WakeOnLAN_status = N/A | ||
| + | |WakeOnKeyboard_status = N/A | ||
| + | |WakeOnMouse_status = N/A | ||
| + | |Flashrom_status = OK | ||
| + | |Flashrom_comments = Supported flashrom revision 1010 or higher. | ||
| + | }} | ||
Revision as of 12:51, 28 January 2011
This page lists the coreboot status of the Nokia IP530 mainboard. It's maintained by Marc Bertens.
The Nokia IP330 is originally a Firewall that runs on the proprietary IPSO operating system of Nokia, it was based in the FreeBSD operating system. There is as far as I known no CD support in the orginal BIOS.
The System has no VGA, all console activity must be done through a serial console. At the front the following can be found;
- Power LED
- Fault LED
- 2 Serial interfaces COM1 and COM2
- 3 Ethernet RJ45 sockets
- Reset button
- 1 Compact PCI slot
At the back the following can be found;
- EURO Power connector
- Power switch
- Three FANs for system unit cooling
- One FAN for CPU cooling
Development status
The current development status is; No coreboot running yet
Hardware status
| Device/functionality | Status | Comments | ||||||
|---|---|---|---|---|---|---|---|---|
| CPU | ||||||||
| CPU works | OK | PIII SL5DV (1000 / 256 / 133 / 1.75V) | ||||||
| L1 cache enabled | OK | CPU: L1 I cache: 16K, L1 D cache: 16K | ||||||
| L2 cache enabled | OK | L2 cache is standard for the P3-68X models | ||||||
| L3 cache enabled | N/A | |||||||
| Multiple CPU support | N/A | |||||||
| Multi-core support | N/A | |||||||
| Hardware virtualization | N/A | |||||||
| RAM | ||||||||
| EDO | N/A | |||||||
| SDRAM | OK | upto 4 single sided 128Mb or 4 dual sided 256Mb | ||||||
| SO-DIMM | N/A | |||||||
| DDR | N/A | |||||||
| DDR2 | N/A | |||||||
| DDR3 | N/A | |||||||
| Dual channel support | N/A | |||||||
| ECC support | WIP | Not yet supported by the coreboot 440BX code, but it's on our TODO list. | ||||||
| On-board Hardware | ||||||||
| On-board IDE 3.5" | OK | Primary and secondary controllers, the primary controller has a Compact Flash slot attached on board, as primary drive. | ||||||
| On-board IDE 2.5" | N/A | |||||||
| On-board SATA | N/A | |||||||
| On-board SCSI | N/A | |||||||
| On-board USB | OK | The USB is not routed to any connector, u can be picked up from the board it self, there is an instruction below on this wiki-page how to do this | ||||||
| On-board VGA | N/A | |||||||
| On-board ethernet | OK | Four intel 21143PD controllers. | ||||||
| On-board audio | N/A | |||||||
| On-board modem | N/A | |||||||
| On-board FireWire | N/A | |||||||
| On-board smartcard reader | N/A | |||||||
| On-board CompactFlash | OK | Is wrired are primary drive on primary IDE controller. | ||||||
| On-board PCMCIA | OK | Texas Instruments PCI1225 PCMCIA/Cardbus controller | ||||||
| Add-on slots/cards | ||||||||
| ISA add-on cards | N/A | |||||||
| Audio/Modem-Riser (AMR/CNR) cards | N/A | |||||||
| PCI add-on cards | OK | Tested: With 4 Ethernet adapter card of Nokia (Compact-PCI slots) | ||||||
| Mini-PCI add-on cards | N/A | |||||||
| PCI-X add-on cards | N/A | |||||||
| AGP graphics cards | N/A | |||||||
| PCI Express x1 add-on cards | N/A | |||||||
| PCI Express x2 add-on cards | N/A | |||||||
| PCI Express x4 add-on cards | N/A | |||||||
| PCI Express x8 add-on cards | N/A | |||||||
| PCI Express x16 add-on cards | N/A | |||||||
| PCI Express x32 add-on cards | N/A | |||||||
| HTX add-on cards | N/A | |||||||
| Legacy / Super I/O | ||||||||
| Floppy | N/A | |||||||
| Serial port 1 (COM1) | OK | |||||||
| Serial port 2 (COM2) | OK | |||||||
| Parallel port | N/A | |||||||
| PS/2 keyboard | OK | Internal 4 pin connector J-KBD | ||||||
| PS/2 mouse | N/A | |||||||
| Game port | N/A | |||||||
| Infrared | N/A | |||||||
| PC speaker | N/A | |||||||
| DiskOnChip | N/A | |||||||
| Miscellaneous | ||||||||
| Sensors / fan control | WIP | |||||||
| Hardware watchdog | N/A | |||||||
| SMBus | WIP | |||||||
| CAN bus | N/A | |||||||
| CPU frequency scaling | N/A | |||||||
| Other powersaving features | N/A | |||||||
| ACPI | No | There's no ACPI implementation for this board, but it's on our TODO list. | ||||||
| Reboot | N/A | |||||||
| Poweroff | N/A | |||||||
| Suspend | Unknown | |||||||
| Nonstandard LEDs | OK | Special-purpose LEDs available on the board, Alert and Fault are controlled by the superio | ||||||
| High precision event timers (HPET) | N/A | |||||||
| Random number generator (RNG) | N/A | |||||||
| Wake on modem ring | N/A | |||||||
| Wake on LAN | N/A | |||||||
| Wake on keyboard | N/A | |||||||
| Wake on mouse | N/A | |||||||
| Flashrom | OK | Supported flashrom revision 1010 or higher. | ||||||