Difference between revisions of "Soldering a socket on your board"

From coreboot
Jump to: navigation, search
(Start a HOWTO about soldering a socket on your board (which has a soldered-on ROM chip).)
 
m
Line 24: Line 24:
 
== Resources ==
 
== Resources ==
  
{{PDF-self}}
+
* [http://ward.vandewege.net/blog/2009/03/howto-replace-a-plcc-chip-with-a-socket-ghetto-style/ HOWO: replace a PLCC chip with a socket "ghetto style"] (Tutorial for doing this without desoldering station by cutting the chip)
 +
 
 +
{{PD-self}}

Revision as of 16:04, 26 March 2009

Mainboards where the BIOS chip is soldered onto the board (and not in a socket) are usually problematic for coreboot developers and especially users, as one incorrectly flashed image will render the board unusable.

Requirements

  • A board with soldered-on (PLCC) socket
  • Soldering iron
  • A PLCC socket (SMD type)
  • Desoldering station or heat gun
  • Tweezers
  • ...

Preparation

  • Take a picture of the board and ROM chip. You might need that later in order to add the socket in the correct orientation.

Desolder or cut away the ROM chip

Clean the pads on the board

Prepare the PLCC socket

Solder the socket onto the board

Resources

Public domain I, the copyright holder of this work, hereby release it into the public domain. This applies worldwide.

In case this is not legally possible:
I grant anyone the right to use this work for any purpose, without any conditions, unless such conditions are required by law.