Difference between revisions of "Talk:GIGABYTE GA-M57SLI-S4"

From coreboot
Jump to: navigation, search
(thf)
(2 Mbit ? successreport thf)
Line 7: Line 7:
  
 
on GA M57SLI, is FWH mode used ? is it necessary to use different ID on ID-pins ?
 
on GA M57SLI, is FWH mode used ? is it necessary to use different ID on ID-pins ?
 +
 +
----
 +
'''
 +
badly in need:'''
 +
 +
* report on usability of top hat flash on M57SLI
 +
* is it practical to upgrade the secondary pad with an 2 MBit flash part ?
  
 
----
 
----

Revision as of 23:33, 9 May 2007

swap #CE and #WP and thus route #CE through the #WP jumper with 8 pin SPI possible ? --da Great QUUX 14:24, 28 April 2007 (CEST)



Alternatively, you might flip a standard plcc-32 socket over the mainboard-chip. then wire a secondary plcc-32 socket to it wired 1:1 - except you connect /reset and /oe on the replacment chip, while you route the /oe from the mainboard to an NC pin on the secondary chip. Take off (hot unplug) the socket after successful boot-up to reflash the original chip. (so called "top hat flash" method, use at own risk, no successful report on GA M57 yet)

on GA M57SLI, is FWH mode used ? is it necessary to use different ID on ID-pins ?


badly in need:

  • report on usability of top hat flash on M57SLI
  • is it practical to upgrade the secondary pad with an 2 MBit flash part ?