S2880
YhLu
YhLu at tyan.com
Wed Aug 6 18:07:00 CEST 2003
Ron,
It seems I can not enable XIP_ROM_SIZE and XIP_ROM_BASE. Even I have set
them in Options.lb
Regards
Yinghai Lu
-----邮件原件-----
发件人: YhLu
发送时间: 2003年8月6日 15:17
收件人: YhLu; ebiederman at lnxi.com; ron minnich
抄送: Stefan Reinauer; linuxbios at clustermatic.org
主题: Re: S2880
Ron,
After swap _ROMBASE etc to after ROM_SECTION_SIZE and ROM_SECTION_OFFSET. I
can switch to the normal mode.
But in fallback mode and normal mode ( after reboot) still got problem.
~ # cmos_util -d
# The CMOS Definition table was not found in ram
# CMOS definition table was not found in RAM memory
# Looking for definitions in cmos.layout file
Can not open config file cmos.layout
Regards
Yinghai Lu
-----邮件原件-----
发件人: YhLu
发送时间: 2003年8月6日 11:18
收件人: 'ebiederman at lnxi.com'; ron minnich
抄送: Stefan Reinauer; linuxbios at clustermatic.org
主题: S2880
Eric,
It seems the image that built with can not switch to Normal booting.
1. In Fallback mode, after power on I can use cmos_util.
2. after rebooting it is still in Fallback mode,and can not cmos_util, it
said can not find option table in the ram. And can not access cmos.layout.
When I using old tool, I can switch to normal mode, but need to change
boot_option and last_boot from fallback to normal.
regards
Yinghai Lu
More information about the coreboot
mailing list