DMA on the SC2200 Geode

[Eric W. Biederman]

John Allen <jallen at integraltech.com> writes:

> I don't think we should wait until the kernel loads.  For instance, I sometimes
> load the kernel from the hard drive with BOOT_IDE.  The drive and controller
> should be in dma mode beofre this.  Mainboard setup sounds good..

Put it in the southbridge code, and only call it from mainboard_setup if
you can.

I don't have a large problem with IDE setup in LinuxBIOS but for the most
part I think  it is wasted effort, and quite possibly wasted time
during boot up.  DMA setup is not as easy as just turning on DMA.  You
have to probe the IDE channel, and  verify the drive/drives supports
the kind of DMA you wan to do.   And even in PIO mode you get 3MB/s.

Also look at the etherboot IDE code.  It was initially derived from
what is in LinuxBIOS but I think it is a little cleaner.  At the very
least I haven't run across a drive it has spin up issues with.  

For the most part if you can get/write a Linux driver for this kind of
things and it is satisfactory I don't see a problem.

Eric