read the source ron!
ron minnich
rminnich at lanl.gov
Thu Oct 2 11:26:34 CEST 2003
On Thu, 2 Oct 2003, Andrew Ip wrote:
> Hi,
>
> Kevin did this fine job in v1. Basically it assigns irqs for PCI devices
> in case of PIRQ table doesn't work. I have been using in different
> place. I also think it would be nice to do it in config file instead
> of in source just like geode. Ron, does epia work now?
>
I'm not getting any ethernet interrupts. The packets get out, they get
responsded to, but the node never gets the interrupt.
Also, I get these messages after a while:
eth0: Transmit timed out, status 1003, PHY status 786d, resetting...
I assume this means no TX IRQ. Blast. What do I look for?
ron
More information about the coreboot
mailing list