jump to boot code
ginlin at nexcom.com.tw
Wed Dec 1 20:01:01 CET 2004
I tested my payload(FILO.elf) with linux loader Grub. It has no problem
at all. So something must go wrong when linuxbios jumps to the payload.
FILO doesn't seem to run at all. No debug message over the console.
Don't' know if there is anyone familiar with ELF.
This is the message over the console at the end.
It seems that there are 2 segments in the ELF. In the end, linuxbios
jumps to an entry that looks like the in the middle of the first
Does it look right?
Found ELF candiate at offset 0
(cleaned up) New segment addr 0x100000 size 0x270f0 offset 0xa0
(cleaned up) New segment addr 0x127100 size 0x48 offset 0xd120 filesize
Dropping non PT_LOAD segment
Loading Segment: addr: 0x0000000000100000 memsz: 0x00000000000270f0
filesz: 0x00 0000000000d068
Loading Segment: addr: 0x0000000000127100 memsz: 0x0000000000000048
filesz: 0x00 00000000000048
Jumping to boot code at 0x1092e4
entry = 0x001092e4
lb_start = 0x00004000
lb_size = 0x00024000
adjust = 0xfe5d8400
buffer = 0xfe5b8400
elf_boot_notes = 0x00015680
adjusted_boot_notes = 0xfe5eda80
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the coreboot