epia problem

mark.wilkinson at 2pmtech.com mark.wilkinson at 2pmtech.com
Thu Dec 2 22:58:01 CET 2004

Hi Luc,
       Can you check that you have the following lines in



I had a similar problem until I added these.

You should see LB getting a little further.

Mark Wilkinson

Quoting Luc Belliveau <luc at bigdata.nb.ca>:

> I compiled from freebios2 from cvs, when I boot all I get back from the
> serial port is:
> LinuxBIOS- <date> starting..
> vt8601 init starting
> Slot 00 is SDRAM 04000000 bytes x2
> Slot 01 is empty
> Slot 02 is empty
> Slot 03 is empty
> vt8601 is done
> that's it.  I tried changing the DEFAULT_CONSOLE_LOGLEVEL but when I do
> that the resulting rom stops at Slot 00 is SDRAM 04000000 bytes x2.
> I can't add uses DEFAULT_CONSOLE_LOGLEVEL or option
> DEFAULT_CONSOLE_LOGLEVEL in the Config.lb file either, the buildtarget
> scripts shuns it.
> I'm using FILO as the payload, with no vga bios yet.
> Could it be a FILO problem?  I've never seen linuxBIOS before yesterday
> so I don't know what should be appearing on the terminal..
> Any assistance would be appreciated :)
> Luc
> _______________________________________________
> Linuxbios mailing list
> Linuxbios at clustermatic.org
> http://www.clustermatic.org/mailman/listinfo/linuxbios

This message was sent using ISPMailNow.com

More information about the coreboot mailing list