Filo Error Help
Hendricks David W.
dwh at lanl.gov
Thu Jul 8 17:36:01 CEST 2004
Looks more like a Linux config problem. Double check your /etc/fstab and
make sure the root partition entry is correct and that you have virtual
terminal (VT) support enabled in your kernel.
On Thu, 8 Jul 2004, David Aubin wrote:
> With your elf I get the following:
> boot: uda1:/ram0_2.5_2.6.5_k8.2_mydisk7.elf
> LinuxLabs USB bootloader
> New USB device, setting address 2
> Manufacturor: Kingston
> Product: DataTraveler2.0
> Serial: 07B1F140E000617B
> Found USB block device 2
> Mounted reiserfs
> boot: uda1:/ram.elf
> Loading Linux version 2.6.5 (root at tst288xsuse9) #11 SMP Mon May 10
> 14:58:17 PDT 2004...
> Jumping to entry point...
> DFA Just before C's xstart32
> Firmware type: LinuxBIOS
> old bootloader convention, maybe loadlin?
> Bootdata ok (command line is root=/dev/ram0 rw console=tty0
> RAMDISK driver initialized: 16 RAM disks of 16384K size 1024 blocksize
> loop: loaded (max 8 devices)
> usb 2-3: new full speed USB device using address 2
> scsi4 : SCSI emulation for USB Mass Storage devices
> Vendor: Kingston Model: DataTraveler2.0 Rev: 4.70
> Type: Direct-Access ANSI SCSI revision: 02
> SCSI device sda: 1019392 512-byte hdwr sectors (522 MB)
> sda: assuming Write Enabled
> sda: assuming drive cache: write through
> sda: sda1
> Attached scsi removable disk sda at scsi4, channel 0, id 0, lun 0
> NET: Registered protocol family 2
> IP: routing cache hash table of 2048 buckets, 32Kbytes
> TCP: Hash tables configured (established 65536 bind 65536)
> NET: Registered protocol family 1
> NET: Registered protocol family 17
> RAMDISK: Compressed image found at block 0
> RAMDISK: incomplete write (-28 != 1) 16777216
> crc error
> EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
> VFS: Mounted root (ext2 filesystem).
> Freeing unused kernel memory: 472k freed
> Kernel panic: No init found. Try passing init= option to kernel.
> This makes me feel a little better as it appears it is something
> in my etherboot-filo configuration perhaps?
> On Thu, 2004-07-08 at 17:53, YhLu wrote:
> > I wonder if it is after gzip or before gzip.
> > -----Original Message-----
> > From: ron minnich [mailto:rminnich at lanl.gov]
> > Sent: Thursday, July 08, 2004 2:44 PM
> > To: David Aubin
> > Cc: YhLu; LinuxBIOS
> > Subject: RE: Filo Error Help
> > On Thu, 8 Jul 2004, David Aubin wrote:
> > > If so could it be a size issue? My initrd is 8Meg.
> > oh!
> > did you config the kernel for that? default is 4M.
> > ron
> Linuxbios mailing list
> Linuxbios at clustermatic.org
More information about the coreboot