Freebios2 recovery progress...

[YhLu]

It's OK.

PCI: 04:01.0 bridge ctrl <- 0003
PCI: 04:01.0 cmd <- 146
PCI: 05:04.0 cmd <- 142
PCI: 04:01.1 subsystem <- 10f1/2895
PCI: 04:01.1 cmd <- 146
PCI: 04:02.0 bridge ctrl <- 0003
PCI: 04:02.0 cmd <- 147
PCI: 06:06.0 cmd <- 143
PCI: 06:06.1 cmd <- 143

-----Original Message-----
From: YhLu 
Sent: Thursday, October 21, 2004 12:11 PM
To: 'ebiederman at lnxi.com'
Cc: LinuxBIOS
Subject: RE: Freebios2 recovery progress...

I will test that on s2885.

I suspect that will need MEM enable too.

YH

-----Original Message-----
From: ebiederman at lnxi.com [mailto:ebiederman at lnxi.com] 
Sent: Thursday, October 21, 2004 11:39 AM
To: YhLu
Cc: LinuxBIOS
Subject: Re: Freebios2 recovery progress...

YhLu <YhLu at tyan.com> writes:

> You can not test that in arima board. Because all device on 8131 is using
> ioapic in amd8111.

I can't test that it works but I can test that the bits are getting
set by running lspci.   And that is how I tested.  The bus
master bit is still getting set.  I just move the location.

Eric