[LinuxBIOS] [PATCH] flashrom patch for iwill dk8_htx

[Mondrian Nuessle]

The attached patch enables flashing on the Iwill DK8-HTX board.
Basically, it configures the SuperIO to set the right GPIO pins, so
write protection is disabled.

Signed-off-by: Mondrian Nuessle <nuessle at uni-mannheim.de>
---

Ok, this is the third try :-)

* I changed the name argument to "const char*" (as suggested by Uwe,
applied that to all boards, of course)
* I fixed indent, as specified by the coding styles, notice that this
bloats the patch considerably, since a lot of existing code is touched
* fixed several typos, comments etc
* I tested this patch on real hardware, both booted by factory BIOS and
LinuxBIOS
* regarding the naming of the boards, these are the names as used in the
LinuxBIOS config and therefore correct (i.e. LinuxBIOS identifies the
dk8-htx board as iwill:dk8_htx, I did never check the the ARUMA...)
* added some explanation to the README

Regards,
Mondrian

-- 
 Mondrian Nuessle                 University of Mannheim
 Phone: +49 621 181 2717          Computer Architecture Group
 Fax:   +49 621 181 2713          http://ra.ti.uni-mannheim.de
 mailto:nuessle at uni-mannheim.de

-------------- next part --------------
A non-text attachment was scrubbed...
Name: iwill_dk8htx_board_enable.patch
Type: text/x-patch
Size: 14352 bytes
Desc: not available
URL: <http://www.coreboot.org/pipermail/coreboot/attachments/20070427/057edaa6/attachment.patch>