[LinuxBIOS] EPIA fix for non working IDE
stuge-linuxbios at cdy.org
Sun Apr 29 18:48:55 CEST 2007
please keep the discussion on the list. Thanks!
On Sun, Apr 29, 2007 at 05:27:29PM +0100, Ben Hewson wrote:
> >Hm, I don't know about this, this file is used with
> >densitron/dpx114 also and it should also have this fixup in
> Does the densitron/dpx114 board still boot with the current
> version of LB ?
I don't know, but let's try not to make it any worse in any case.
> >Ben, is there really no way to have that register setting in the
> >8231 code in v2?
> I can think of only 2 reasons why the write to register 0x42 does
> not work properly in ide_init(). Either it must be done before the
> IDE peripheral is enabled (it is disabled by default)
This makes sense.
> or it is a timing issue.
Also possible, but mode before enable seems more likely.
> If we move the fix from auto.c it would probably need to go before
> the IDE enable in vt8231_init().
> At this point dev does not point to the correct PCI section,
> however the 2 lines of code in auto.c could be moved there.
Sure, finding the IDE device is neccessary.
> Alternatively the IDE enable in vt8231_init() could be moved to
> ide_init(), but again dev does not then point to the correct PCI
> registers to enable the IDE.
> Not sure which solution would be the most elegant. Do you have any
> preference ?
Not sure there is an elegant solution to this in v2 but I prefer the
first solution, set compatibility mode before enabling IDE in _init.
More information about the coreboot