[LinuxBIOS] EPIA hang after patch

Markus bios at ryven.de
Tue Jun 12 21:24:53 CEST 2007


Am Tue, 12 Jun 2007 09:48:47 +0200
schrieb ben at hewson-venieri.co.uk:
The Epia V has only one SD-Ram Slot.
And badly is like "only" Infineon Chips. :-(

Markus
> Can you try using just 1 memory module to start with and see if that
> helps.
> 
> 
> 
> >Hi!
> >
> >I checked out r2717 and at first it behaved like Markus Boas Epia V
> >but then I applied Ben's patch to the vt8231_early_serial.c and it
> >booted into filo, once, then hanged at the dram setup. then I applied
> >the vt8231_lpc.c patch and it hangs on this:
> >
> >LinuxBIOS-2.0.0.0Normal Mon Jun 11 22:28:57 CEST 2007 starting...
> >87 is the comm register
> >SMBus controller enabled
> >vt8601 init starting
> >00000000 is the north
> >                     1106 0601
> >0120d4 is the computed timing
> >                             NOP
> >PRECHARGE
> >DUMMY READS
> >CBR
> >MRS
> >NORMAL
> >set ref. rate
> >enable multi-page open
> >Slot 00 is SDRAM 10000000 bytes
> >000e is the MA type
> >Slot 01 is SDRAM 08000000 bytes x2
> >000c is the MA type
> >Slot 02 is empty
> >Slot 03 is empty
> >vt8601 done
> >Copying LinuxBIOS to RAM.
> >Jumping to LinuxBIOS.
> >LinuxBIOS-2.0.0.0Normal Mon Jun 11 22:28:57 CEST 2007 booting...
> >Enumerating buses...
> >scan_static_bus for Root Device
> >Finding PCI configuration type.
> >PCI: Using configuration type 1
> >PCI_DOMAIN: 0000 enabled
> >APIC_CLUSTER: 0 enabled
> >PCI_DOMAIN: 0000 scanning...
> >PCI: pci_scan_bus for bus 00
> >PCI: 00:00.0 [1106/0601] ops
> >PCI: 00:00.0 [1106/0601] enabled
> >malloc Enter, size 668, free_mem_ptr 00018000
> >malloc 0x00018000
> >Capability: 0x07 @ 0x80
> >Capability: 0x08 @ 0x80
> >Capability: 0x10 @ 0x80
> >PCI: 00:01.0 [1106/8601] enabled
> >PCI: devfn 0x10, bad id 0xffffffff
> >PCI: devfn 0x18, bad id 0xffffffff
> >PCI: devfn 0x20, bad id 0xffffffff
> >PCI: devfn 0x28, bad id 0xffffffff
> >PCI: devfn 0x30, bad id 0xffffffff
> >PCI: devfn 0x38, bad id 0xffffffff
> >PCI: devfn 0x40, bad id 0xffffffff
> >PCI: devfn 0x48, bad id 0xffffffff
> >PCI: devfn 0x50, bad id 0xffffffff
> >PCI: devfn 0x58, bad id 0xffffffff
> >PCI: devfn 0x60, bad id 0xffffffff
> >PCI: devfn 0x68, bad id 0xffffffff
> >PCI: devfn 0x70, bad id 0xffffffff
> >PCI: devfn 0x78, bad id 0xffffffff
> >PCI: devfn 0x80, bad id 0xffffffff
> >PCI: 00:11.0 [1106/8231] bus ops
> >PCI: 00:11.0 [1106/8231] enabled
> >PCI: 00:11.1 [1106/0571] ops
> >PCI: 00:11.1 [1106/0571] enabled
> >PCI: 00:11.2 [1106/3038] disabled
> >PCI: 00:11.3 [1106/3038] disabled
> >PCI: 00:11.4 [1106/8235] ops
> >PCI: 00:11.4 [1106/8235] disabled
> >PCI: 00:11.5 [1106/3058] disabled
> >PCI: 00:11.6 [1106/3068] enabled
> >PCI: devfn 0x8f, bad id 0xffffffff
> >PCI: 00:12.0 [1106/3065] ops
> >PCI: 00:12.0 [1106/3065] enabled
> >PCI: devfn 0x98, bad id 0xffffffff
> >malloc Enter, size 668, free_mem_ptr 0001829c
> >malloc 0x0001829c
> >PCI: 00:14.0 [1106/3065] ops
> >PCI: 00:14.0 [1106/3065] enabled
> >PCI: devfn 0xa8, bad id 0xffffffff
> >PCI: devfn 0xb0, bad id 0xffffffff
> >PCI: devfn 0xb8, bad id 0xffffffff
> >PCI: devfn 0xc0, bad id 0xffffffff
> >PCI: devfn 0xc8, bad id 0xffffffff
> >PCI: devfn 0xd0, bad id 0xffffffff
> >PCI: devfn 0xd8, bad id 0xffffffff
> >PCI: devfn 0xe0, bad id 0xffffffff
> >PCI: devfn 0xe8, bad id 0xffffffff
> >PCI: devfn 0xf0, bad id 0xffffffff
> >PCI: devfn 0xf8, bad id 0xffffffff
> >do_pci_scan_bridge for PCI: 00:01.0
> >PCI: pci_scan_bus for bus 01
> >PCI: devfn 0x0, bad id 0xffffffff
> >PCI: devfn 0x8, bad id 0xffffffff
> >PCI: devfn 0x10, bad id 0xffffffff
> >PCI: devfn 0x18, bad id 0xffffffff
> >PCI: devfn 0x20, bad id 0xffffffff
> >PCI: devfn 0x28, bad id 0xffffffff
> >PCI: devfn 0x30, bad id 0xffffffff
> >PCI: devfn 0x38, bad id 0xffffffff
> >PCI: devfn 0x40, bad id 0xffffffff
> >PCI: devfn 0x48, bad id 0xffffffff
> >PCI: devfn 0x50, bad id 0xffffffff
> >PCI: devfn 0x58, bad id 0xffffffff
> >PCI: devfn 0x60, bad id 0xffffffff
> >PCI: devfn 0x68, bad id 0xffffffff
> >PCI: devfn 0x70, bad id 0xffffffff
> >PCI: devfn 0x78, bad id 0xffffffff
> >PCI: devfn 0x80, bad id 0xffffffff
> >PCI: devfn 0x88, bad id 0xffffffff
> >PCI: devfn 0x90, bad id 0xffffffff
> >PCI: devfn 0x98, bad id 0xffffffff
> >PCI: devfn 0xa0, bad id 0xffffffff
> >PCI: devfn 0xa8, bad id 0xffffffff
> >PCI: devfn 0xb0, bad id 0xffffffff
> >PCI: devfn 0xb8, bad id 0xffffffff
> >PCI: devfn 0xc0, bad id 0xffffffff
> >PCI: devfn 0xc8, bad id 0xffffffff
> >PCI: devfn 0xd0, bad id 0xffffffff
> >PCI: devfn 0xd8, bad id 0xffffffff
> >PCI: devfn 0xe0, bad id 0xffffffff
> >PCI: devfn 0xe8, bad id 0xffffffff
> >PCI: devfn 0xf0, bad id 0xffffffff
> >PCI: devfn 0xf8, bad id 0xffffffff
> >PCI: pci_scan_bus returning with max=001
> >do_pci_scan_bridge returns max 1
> >scan_static_bus for PCI: 00:11.0
> >malloc Enter, size 668, free_mem_ptr 00018538
> >malloc 0x00018538
> >malloc Enter, size 668, free_mem_ptr 000187d4
> >malloc 0x000187d4
> >malloc Enter, size 668, free_mem_ptr 00018a70
> >malloc 0x00018a70
> >malloc Enter, size 668, free_mem_ptr 00018d0c
> >malloc 0x00018d0c
> >malloc Enter, size 668, free_mem_ptr 00018fa8
> >malloc 0x00018fa8
> >malloc Enter, size 668, free_mem_ptr 00019244
> >malloc 0x00019244
> >malloc Enter, size 668, free_mem_ptr 000194e0
> >malloc 0x000194e0
> >malloc Enter, size 668, free_mem_ptr 0001977c
> >malloc 0x0001977c
> >malloc Enter, size 668, free_mem_ptr 00019a18
> >malloc 0x00019a18
> >malloc Enter, size 668, free_mem_ptr 00019cb4
> >malloc 0x00019cb4
> >malloc Enter, size 668, free_mem_ptr 00019f50
> >malloc 0x00019f50
> >PNP: 002e.0 disabled
> >PNP: 002e.1 disabled
> >PNP: 002e.2 enabled
> >PNP: 002e.3 disabled
> >PNP: 002e.5 enabled
> >PNP: 002e.6 disabled
> >PNP: 002e.7 disabled
> >PNP: 002e.8 disabled
> >PNP: 002e.9 disabled
> >PNP: 002e.a disabled
> >PNP: 002e.b enabled
> >PNP: 607a.0 enabled
> >PNP: 607a.1 enabled
> >PNP: 607a.2 enabled
> >PNP: 607a.3 enabled
> >PNP: 607a.5 enabled
> >PNP: 607a.6 enabled
> >PNP: 607a.7 enabled
> >PNP: 607a.8 enabled
> >PNP: 607a.9 enabled
> >PNP: 607a.a enabled
> >PNP: 607a.b enabled
> >scan_static_bus for PCI: 00:11.0 done
> >PCI: pci_scan_bus returning with max=001
> >Unexpected Exception: 6 @ 10:e2c3f00a - Halting
> >Code: 0 eflags: 00010093
> >eax: ffffff00 ebx: 00000000 ecx: 000003f8 edx: 00017eec
> >edi: 00000000 esi: 00000000 ebp: 00000000 esp: 00010004
> >
> >
> >Any ideas would be great!
> >
> >Thanks!
> >/Thomas
> >
> >-- 
> >linuxbios mailing list
> >linuxbios at linuxbios.org
> >http://www.linuxbios.org/mailman/listinfo/linuxbios
> 




More information about the coreboot mailing list