[LinuxBIOS] Geode LX support
marc.jones at amd.com
Tue May 22 01:27:04 CEST 2007
Indrek Kruusa wrote:
> Could it be that setup for one LX board (amd/norwitch) does something very
> special that prevents this LB ROM to run (to some extent) on another LX board
> (artecgroup/dbe61)? It stops at postcode 0x10 (Entry into protected mode). I
> suppose that whatever LX target rom should be able to reach at least the
> pll_reset() on any another LX board without much problem.
The only thing I could think of is that new LX code uses CAR so if you
were still trying to use romcc you would run into problems right away.
Is the problem at the first 0x10 or does it actually do the pll_reset()
and stop on the second time around? Can you get serial output?
Senior Software Engineer
(970) 226-9684 Office
mailto:Marc.Jones at amd.com
More information about the coreboot