[LinuxBIOS] Epia V

[Markus Boas]

Hi I have littel trouble with this mainboard.
First: Is this normal?

<shnip>
Capability: 0x10 @ 0x80
PCI: 00:01.0 [1106/8601] enabled
PCI: devfn 0x10, bad id 0xffffffff
PCI: devfn 0x18, bad id 0xffffffff
PCI: devfn 0x20, bad id 0xffffffff
PCI: devfn 0x28, bad id 0xffffffff
PCI: devfn 0x30, bad id 0xffffffff
PCI: devfn 0x38, bad id 0xffffffff
PCI: devfn 0x40, bad id 0xffffffff
PCI: devfn 0x48, bad id 0xffffffff
PCI: devfn 0x50, bad id 0xffffffff
PCI: devfn 0x58, bad id 0xffffffff
PCI: devfn 0x60, bad id 0xffffffff
PCI: devfn 0x68, bad id 0xffffffff
PCI: devfn 0x70, bad id 0xffffffff
PCI: devfn 0x78, bad id 0xffffffff
PCI: devfn 0x80, bad id 0xffffffff
PCI: 00:11.0 [1106/8231] bus ops
PCI: 00:11.0 [1106/8231] enabled
PCI: 00:11.1 [1106/0571] ops
PCI: 00:11.1 [1106/0571] enabled
PCI: 00:11.2 [1106/3038] disabled
PCI: 00:11.3 [1106/3038] disabled
PCI: 00:11.4 [1106/8235] ops
<snap>

I'm worry about  the bad id.

Second:
I used etherboot as payload, but it didn't came up.
The last output from the serial communcation:

<shnip>
LinuxBIOS-2.0.0.0Fallback Sun May 27 20:19:19 UTC 2007 starting...
87 is the comm register
SMBus controller enabled
vt8601 init starting
00000000 is the north
                     1106 0601
0120d4 is the computed timing
                             NOP
PRECHARGE
DUMMY READS
CBR
MRS
NORMAL
set ref. rate
enable multi-page open
Slot 00 is SDRAM
<snap>

On screen runs a defect ascii-output throu 

Markus