[coreboot] i2c-i810 code

joe at smittys.pointclark.net joe at smittys.pointclark.net
Tue Apr 8 16:43:47 CEST 2008

>>> What exactly do you intend to do? Where's this code needed?
>> This code will enable communications with the Conexant CX25873 tv-out
>> chip via i2c through the northbridge GPIO lines. Then I can program
>> the tv-out registers and initialize it. I'm still not exactly sure
>> where this code will run. If can run before VGA is initialized that
>> would be great. But it may have to run after, to get the correct clock
>> and timing signals from the northbridge graphics, which means a
>> modification to the coreboot core code.
> Anyone know from what file the vga device init code is from???
Ok, looks like it just uses the default init. Also looks like I won't  
have to modify any coreboot core code to run the i2c-i810 after VGA is  
initialized. I can just setup a vga.c file in the northbridge for a  
custom vga init, and call it from there. Kind of like Corey did for  
the Via CN700, thanks Corey :-)

Thanks - Joe

More information about the coreboot mailing list