[coreboot] Stepping in boot code of DB800 via JTAG
llandre
r&d2 at dave-tech.it
Wed Apr 23 09:08:19 CEST 2008
The technical support from mips.com helped me to solve the problem. It
is necessary to issue the following command first:
config disabletrace on
Regards,
llandre
DAVE Electronics System House - R&D Department
web: http://www.dave.eu
email: r&d2 at dave-tech.it
> llandre wrote:
>> I successfully booted the DB800 evaluation board with coreboot v2,
>> however I can't step the boot code via JTAG (FS2 System Navigator).
>> Following is the console dump.
>> Anybody experienced the same problem?
>
> llandre,
>
> I think you need to halt before you step. On a reset the CPU runs unless
> you put it into debug stall via the bootstrap options. See
> GLCP_SYS_RSTPLL 4C000014h.
>
> Marc
>
More information about the coreboot
mailing list