[coreboot] Fwd: Unable to power up db800 with coreboot
Phani Babu Giddi
phanig at gmail.com
Wed Feb 27 01:56:11 CET 2008
---------- Forwarded message ----------
From: Phani Babu Giddi <phanig at gmail.com>
Date: Tue, Feb 26, 2008 at 4:55 PM
Subject: Re: [coreboot] Unable to power up db800 with coreboot
To: Marc Jones <marc.jones at amd.com>
Not sure if that is the case because after programming the chip I verify the
contents and they are same. Btw the flash chip that I am using is Intel's
N82802AB which is of the same size as the flash part that the board was
shipped with SST49LF004B.
One more thing, I have built coreboot manually instead of using buildrom
after which i have patched vsa.
On Tue, Feb 26, 2008 at 2:54 PM, Marc Jones <marc.jones at amd.com> wrote:
> Phani Babu Giddi wrote:
> > Hi Marc,
> > I was able to build coreboot for db800 board using the latest codebase
> > 3118 on SLES. Fedora still doesnt work for me. So I have build coreboot
> > image with FILO as the payload. When I powerup the system the Linux
> > image doesnt boot. On the IDE disk I have installed SLES with /boot in a
> > different partition. /boot is ext2 and / is reiserfs. The system does
> > nothing for a long time and after wards USB LED's on the board come up.
> > I was expecting some messages on the serial console and the montior but
> > I dont see any. Any idea whats going on. The FILO config file is as
> > shown below, i hope I am not passing incorrect parameters here....
> > Regards,
> > Phani
> This seems like the ROM didn't get programmed correctly. You should get
> something on the serial port. Note I think that there is a errata on
> some db800s where the serial doesn't work on a reset (should work from
> power off). Information should be available from Logic.
> Marc Jones
> Senior Firmware Engineer
> (970) 226-9684 Office
> mailto:Marc.Jones at amd.com
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the coreboot