[coreboot] [Fwd: Re: flashrom and the dbm690t]

[Marc Jones]

ron minnich wrote:
> I can easily read from the chip on the board.
> 
> But, hot plugging is not working out.
> 
> The basic part is a 49lf008a; putting in 49lf008 or 49lf080 just gets
> reads back of ff.
> 
> Ideas welcome. Do BIos saviours exist any more?
>

But you can read out the original ROM file? If you switch to FWH
(49lf008a) you will need to set FakeAsrEn [PM_Reg:8Fh] UseBypassRom[1]
and BypassRomSel[3:2].

You can check the range :
LPC ROM Address Range 2 (Start Address)- RW - 16 bits - [PCI_Reg: 6Ch]
LPC ROM Address Range 2 (End Address) - RW - 16 bits - [PCI_Reg: 6Eh]
It should be 0xfffffff0 meaning 0xfff00000-0xffffffff

Rom Protect 0 - RW - 32 bits - [PCI_Reg: 50h]
Should be 0.

That is all I can think of at the moment.

Marc


-- 
Marc Jones
Senior Firmware Engineer
(970) 226-9684 Office
mailto:Marc.Jones at amd.com
http://www.amd.com/embeddedprocessors