[coreboot] powering machine on after reboot

Chris Kinney cmkinne at sandia.gov
Fri May 29 01:02:02 CEST 2009


im booting up a machine with coreboot and anytime i reboot the machine 
it never turns back on, i have to turn it back on by hand. i ran the 
nvramtool to see the bio settings and  got this:

boot_option = Normal
last_boot = Normal
ECC_memory = Enable
baud_rate = 115200
hw_scrubber = Enable
interleave_chip_selects = Enable
max_mem_clock = 166Mhz
dual_core = Enable
power_on_after_fail = Enable
debug_level = Info
boot_first = Network
boot_second = Fallback_Network
# Bad value -> boot_third = 0xf
boot_index = 0x0
boot_countdown = 0x0
slow_cpu = off
nmi = Disable
iommu = Disable
nvramtool: Can not read coreboot parameter user_data because layout info 
specifies CMOS area that is too wide.

i changed the boot_on_after_fail to Enable thinking that would fix my 
issue but it didnt.

does anyone have any other ideas on what other parameter could fix this?





More information about the coreboot mailing list