[coreboot] Advice how to install Linux to get it working with FILO

[Joop Boonen]

Hello All,

I want to get FILO working on my system (arima/hdama).
As I want to rule out my Linux installation I have a few questions.
I've installed openSuSE 11.2 x86_64 on a SATA disk connected to the on
board SIL3114 controller.

I have the follwoing partitioning.
1) /boot about 128 MB
2) swap about 2 GB
3) /root about 60GB
4) /home about 20GB

Is this OK or is there also a track maximum for FILO like existed for LILO?
Is it best to configure FILO with grub commands?

Regards,

Joop.