<br>
<div><span class="gmail_quote"></span>
<div>
<div>Hello LinuxBios elders,</div>
<div> </div>
<div>I'm sorry to bother you.</div>
<div> </div>
<div>I'm begining to study LinuxBios and I have some problem in it.</div>
<div>Hope you can give me some idea.</div>
<div> </div>
<div>My target board is an AMD Opteron (chipset: K8 / 8111 / 8131) mainboard,</div>
<div>it is similar to Tyan s2880 / s2881 / s2882.</div>
<div> </div>
<div>So I base on Tyan s2880 to change some config file to compile a linuxbios.rom,</div>
<div>but it doesn't work.</div>
<div> </div>
<div>Following is what do I changed in s2880:</div>
<div>1. I changed the payload path in targets/tyan/s2880/Config.lb.</div>
<div>2. modify src/mainboard/tyan/s2880/Config.lb as 42812-pci.txt. ( as attachment )</div>
<div>    I don't know is it correct that I modified. If you have interest you can refer to Attachment.</div>
<div>3. generated irq_tables.c by getpir.c and replaced the original one.</div>
<div> </div>
<div>compile and burn it in rom.</div>
<div> </div>
<div>After I boot up the target board, it always alert emergency beep.</div>
<div> </div>
<div>Then, I unmark some debug message in 'src/northbridge/amd/amdk8/raminit.c' to see where is it hang.</div>
<div>The last step is hang on setup_default_resource_map() in 'src/mainboard/tyan/s2880/cache_as_ram_auto.c',</div>
<div>I can see it from serial console ( as attachment again. ) </div>
<div> </div>
<div>Is there any configuration I should change, and I didn't do ?</div>
<div>How can I debug it ?</div>
<div> </div>
<div>Thanks a lot.</div>
<div> </div>
<div><br><br>-- <br>Best Regards,<br>Vincente Tsou<br><br>Engineer<br>R/D, S/W Dept.<br>NEXCOM International Co.<br>Tel: 886-2-82280606 Ext. 3205<br>Fax: 886-2-82280506<br>E-mail: <a href="mailto:vincentetsou@nexcom.com.tw">
vincentetsou@nexcom.com.tw</a><br>Web: <a href="http://www.nexcom.com.tw/">http://www.nexcom.com.tw/</a> </div></div></div>