<br><br>
<div class="gmail_quote">---------- Forwarded message ----------<br>From: <b class="gmail_sendername">Phani Babu Giddi</b> <<a href="mailto:phanig@gmail.com">phanig@gmail.com</a>><br>Date: Tue, Feb 26, 2008 at 4:55 PM<br>
Subject: Re: [coreboot] Unable to power up db800 with coreboot<br>To: Marc Jones <<a href="mailto:marc.jones@amd.com">marc.jones@amd.com</a>><br><br><br>
<div>Hi Marc,</div>
<div> </div>
<div>Not sure if that is the case because after programming the chip I verify the contents and they are same. Btw the flash chip that I am using is Intel's N82802AB which is of the same size as the flash part that the board was shipped with SST49LF004B.</div>

<div> </div>
<div>One more thing, I have built coreboot manually instead of using buildrom after which i have patched vsa.</div>
<div> </div>
<div>Regards,</div>
<div>Phani<font color="#888888"><br><br></font></div>
<div>
<div></div>
<div class="Wj3C7c">
<div class="gmail_quote">On Tue, Feb 26, 2008 at 2:54 PM, Marc Jones <<a href="mailto:marc.jones@amd.com" target="_blank">marc.jones@amd.com</a>> wrote:<br>
<blockquote class="gmail_quote" style="PADDING-LEFT: 1ex; MARGIN: 0px 0px 0px 0.8ex; BORDER-LEFT: #ccc 1px solid">
<div><br><br><br>Phani Babu Giddi wrote:<br>> Hi Marc,<br>><br>> I was able to build coreboot for db800 board using the latest codebase<br>> 3118 on SLES. Fedora still doesnt work for me. So I have build coreboot<br>
> image with FILO as the payload. When I powerup the system the Linux<br>> image doesnt boot. On the IDE disk I have installed SLES with /boot in a<br>> different partition. /boot is ext2 and / is reiserfs. The system does<br>
> nothing for a long time and after wards USB LED's on the board come up.<br>><br>> I was expecting some messages on the serial console and the montior but<br>> I dont see any. Any idea whats going on. The FILO config file is as<br>
> shown below, i hope I am not passing incorrect parameters here....<br>><br>> Regards,<br>> Phani<br><br></div>Phani,<br><br>This seems like the ROM didn't get programmed correctly. You should get<br>something on the serial port. Note I think that there is a errata on<br>
some db800s where the serial doesn't work on a reset (should work from<br>power off). Information should be available from Logic.<br><br>Marc<br><font color="#888888"><br>--<br>Marc Jones<br>Senior Firmware Engineer<br>
(970) 226-9684 Office<br>mailto:<a href="mailto:Marc.Jones@amd.com" target="_blank">Marc.Jones@amd.com</a><br><a href="http://www.amd.com/embeddedprocessors" target="_blank">http://www.amd.com/embeddedprocessors</a><br><br>
<br></font></blockquote></div><br></div></div></div><br>