Make sure that it is 2MB and now 2Mb(it = 256KB).<br><br>And then pick the right size in coreboot.<br><br>Mvh Anders<br><br>----- Reply message -----<br>Fra: "Oliver Schinagl" <oliver@schinagl.nl><br>Dato: fre., maj 21, 2010 08:36<br>Emne: [coreboot] Indtast Bcc Indtast Bcc Indtast Bcc Wyse S10 and coreboot<br>Til: <coreboot@coreboot.org><br><br>On 05/21/2010 08:28 AM, anders@jenbo.dk wrote:<br>> You will need the developer package of pciutils, use the name on the <br>> wiki it is in the ubuntu repository.<br>I couldn't find it, well unless it's pciutils and pci-utils-dev :p I'll <br>search more.<br>><br>> Yes seabios is the best to start of with, download it via git, and <br>> configure it as a payload (se wiki) then make it.<br>All right.<br>><br>> For coreboot al you need to do is pick s50 as the board, pick the <br>> right Rom size, point to the payload.<br>The romsize defaults to 256k but according to flashrom (And the markings <br>on the chip) it's a 2mb flash unit?<br>Also there's a lot of VGA, VSA and other settings that where very <br>confusing as I read somewhere on the wiki; that the Geode GX2/LX don't <br>support VGA things? And the VSA bit, I found that there is OpenVSA but <br>it's highly experimental? Do I need it at all?<br>> As for network boot you will need an additional tool (look at the wiki).<br>GPXE stuff I belive?<br><br><br>Thank you for your time so far!<br><br>Oliver<br><br>-- <br>coreboot mailing list: coreboot@coreboot.org<br><a href="http://www.coreboot.org/mailman/listinfo/coreboot">http://www.coreboot.org/mailman/listinfo/coreboot</a><br><br><br>