[flashrom] HPT360/HPT370 ATA controller flash interface
Carl-Daniel Hailfinger
c-d.hailfinger.devel.2006 at gmx.net
Thu Feb 4 01:49:48 CET 2010
On 17.01.2010 01:55, Uwe Hermann wrote:
> Here's the first draft. It does not yet work, the chip cannot be
> detected, all reads return 0x00 so far.
>
> Note that the WE# pin is at 3.3V while the HPT card is powered, thus
> writes are _dis_abled, unless I'm mistaken. The WE# pin is connected to
> some pin of the HPT370A chip (probably a GPIO), so it can in theory
> toggle the WE# pin.
>
That would explain why you don't get any probe response. An interesting
experiment would be to write some random image to the chip with a known
good programmer (your mainboard?), then force read the chip in the
HPT360. If that works, you only have to handle WE#. If it doesn't, there
are deeper issues that need to be fixed.
> Index: Makefile
> ===================================================================
> --- Makefile (revision 862)
> +++ Makefile (working copy)
> @@ -84,6 +84,9 @@
> # Always enable SiI SATA controllers for now.
> CONFIG_SATASII ?= yes
>
> +# Always enable Highpoint (HPT) ATA/RAID controllers for now.
> +CONFIG_ATAHPT ?= yes
> +
> # Always enable FT2232 SPI dongles for now.
> CONFIG_FT2232SPI ?= yes
>
>
Following the policy of merging code early as long as users won't trip
over it, change CONFIG_ATAHPT to default to no, and the patch is
Acked-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006 at gmx.net>
If you merge the current tree with your patch, a conflict will arise in
flashrom.c. Suggested resolution:
#if NIC3COM_SUPPORT+GFXNVIDIA_SUPPORT+DRKAISER_SUPPORT+SATASII_SUPPORT+ATAHPT_SUPPORT+FT2232_SPI_SUPPORT+SERPROG_SUPPORT+BUSPIRATE_SPI_SUPPORT+DEDIPROG_SUPPORT > 1
Regards,
Carl-Daniel
--
Developer quote of the year:
"We are juggling too many chainsaws and flaming arrows and tigers."
More information about the flashrom
mailing list