[flashrom] Abit VT6X4/W29C020C success report

[Michael Karcher]

This log appeared in our pastebin, it shows that W29C020C on an Abit
VT6X4 board works fine.

Regards,
  Michael Karcher

$ sudo flashrom -m abit:vt6x4 -r original.bin
flashrom v0.9.1-r908
No coreboot table found.
Found chipset "VIA VT82C686A/B", enabling flash write... OK.
This chipset supports the following protocols: Non-SPI.
Disabling flash write protection for board "Abit VT6X4"...
VIA Apollo ACPI: Dropping GPIO04.
OK.
Calibrating delay loop... OK.
Found chip "Winbond W29C020C" (256 KB, Parallel) at physical address 0xfffc0000.
===
This flash part has status UNTESTED for operations: PROBE READ ERASE WRITE
Please email a report to flashrom at flashrom.org if any of the above operations
work correctly for you with this flash part. Please include the flashrom
output with the additional -V option for all operations you tested (-V, -rV,
-wV, -EV), and mention which mainboard or programmer you tested. Thanks for your help!
===
Reading flash... done.


$ sudo flashrom -m abit:vt6x4 -r old_chip.bin
flashrom v0.9.1-r908
No coreboot table found.
Found chipset "VIA VT82C686A/B", enabling flash write... OK.
This chipset supports the following protocols: Non-SPI.
Disabling flash write protection for board "Abit VT6X4"...
VIA Apollo ACPI: Dropping GPIO04.
OK.
Calibrating delay loop... OK.
Found chip "Winbond W29C020C" (256 KB, Parallel) at physical address 0xfffc0000.
===
This flash part has status UNTESTED for operations: PROBE READ ERASE WRITE
Please email a report to flashrom at flashrom.org if any of the above operations
work correctly for you with this flash part. Please include the flashrom
output with the additional -V option for all operations you tested (-V, -rV,
-wV, -EV), and mention which mainboard or programmer you tested. Thanks for your help!
===
Reading flash... done.


$ sudo flashrom -m abit:vt6x4 -E
flashrom v0.9.1-r908
No coreboot table found.
Found chipset "VIA VT82C686A/B", enabling flash write... OK.
This chipset supports the following protocols: Non-SPI.
Disabling flash write protection for board "Abit VT6X4"...
VIA Apollo ACPI: Dropping GPIO04.
OK.
Calibrating delay loop... OK.
Found chip "Winbond W29C020C" (256 KB, Parallel) at physical address 0xfffc0000.
===
This flash part has status UNTESTED for operations: PROBE READ ERASE WRITE
Please email a report to flashrom at flashrom.org if any of the above operations
work correctly for you with this flash part. Please include the flashrom
output with the additional -V option for all operations you tested (-V, -rV,
-wV, -EV), and mention which mainboard or programmer you tested. Thanks for your help!
===
@@Erasing flash chip... SUCCESS.


$ sudo flashrom -m abit:vt6x4 -r old_chip_erased.bin
flashrom v0.9.1-r908
No coreboot table found.
Found chipset "VIA VT82C686A/B", enabling flash write... OK.
This chipset supports the following protocols: Non-SPI.
Disabling flash write protection for board "Abit VT6X4"...
VIA Apollo ACPI: Dropping GPIO04.
OK.
Calibrating delay loop... OK.
Found chip "Winbond W29C020C" (256 KB, Parallel) at physical address 0xfffc0000.
===
This flash part has status UNTESTED for operations: PROBE READ ERASE WRITE
Please email a report to flashrom at flashrom.org if any of the above operations
work correctly for you with this flash part. Please include the flashrom
output with the additional -V option for all operations you tested (-V, -rV,
-wV, -EV), and mention which mainboard or programmer you tested. Thanks for your help!
===
Reading flash... done.


$ sudo flashrom -m abit:vt6x4 -w original.bin
flashrom v0.9.1-r908
No coreboot table found.
Found chipset "VIA VT82C686A/B", enabling flash write... OK.
This chipset supports the following protocols: Non-SPI.
Disabling flash write protection for board "Abit VT6X4"...
VIA Apollo ACPI: Dropping GPIO04.
OK.
Calibrating delay loop... OK.
Found chip "Winbond W29C020C" (256 KB, Parallel) at physical address 0xfffc0000.
===
This flash part has status UNTESTED for operations: PROBE READ ERASE WRITE
Please email a report to flashrom at flashrom.org if any of the above operations
work correctly for you with this flash part. Please include the flashrom
output with the additional -V option for all operations you tested (-V, -rV,
-wV, -EV), and mention which mainboard or programmer you tested. Thanks for your help!
===
Flash image seems to be a legacy BIOS. Disabling checks.
@@Writing flash chip... Programming page: 2047 at address: 0x0003ff80
@@COMPLETE.
@@Verifying flash... VERIFIED.


$ sudo flashrom -m abit:vt6x4 -v original.bin
flashrom v0.9.1-r908
No coreboot table found.
Found chipset "VIA VT82C686A/B", enabling flash write... OK.
This chipset supports the following protocols: Non-SPI.
Disabling flash write protection for board "Abit VT6X4"...
VIA Apollo ACPI: Dropping GPIO04.
OK.
Calibrating delay loop... OK.
Found chip "Winbond W29C020C" (256 KB, Parallel) at physical address 0xfffc0000.
===
This flash part has status UNTESTED for operations: PROBE READ ERASE WRITE
Please email a report to flashrom at flashrom.org if any of the above operations
work correctly for you with this flash part. Please include the flashrom
output with the additional -V option for all operations you tested (-V, -rV,
-wV, -EV), and mention which mainboard or programmer you tested. Thanks for your help!
===
Flash image seems to be a legacy BIOS. Disabling checks.
@@Verifying flash... VERIFIED.


$ sudo flashrom -m abit:vt6x4 -r old_chip_written.bin
flashrom v0.9.1-r908
No coreboot table found.
Found chipset "VIA VT82C686A/B", enabling flash write... OK.
This chipset supports the following protocols: Non-SPI.
Disabling flash write protection for board "Abit VT6X4"...
VIA Apollo ACPI: Dropping GPIO04.
OK.
Calibrating delay loop... OK.
Found chip "Winbond W29C020C" (256 KB, Parallel) at physical address 0xfffc0000.
===
This flash part has status UNTESTED for operations: PROBE READ ERASE WRITE
Please email a report to flashrom at flashrom.org if any of the above operations
work correctly for you with this flash part. Please include the flashrom
output with the additional -V option for all operations you tested (-V, -rV,
-wV, -EV), and mention which mainboard or programmer you tested. Thanks for your help!
===
Reading flash... done.