Difference between revisions of "Board:jetway/nf81-t56n-lf"

From coreboot
Jump to navigation Jump to search
(restructure)
m
Line 5: Line 5:
== Known Issues ==
== Known Issues ==


* pcie 06.0 bridge sometimes hangs probing the nic behind it. Linux reports a borked IRQ addr. They are likely connected? (Fix ACPI).
* pcie 06.0 bridge sometimes hangs probing the nic behind it. Linux reports a borked IRQ addr. They are likely connected? (Fix ACPI?).
* superio not controlling fan - fix known, patch WIP!
* suspend/resume could do with some work to clean up nasty warnings.. (Fix ACPI).
* suspend/resume could do with some work to clean up nasty warnings.. (Fix ACPI).
* some werid AGESA issue affects a number of boards
* some werid AGESA issue affects a number of boards


== Hardware ==
== Overview ==


=== Overview ===
=== Hardware ===


* '''AMD Fusion G-series''' AMD Fusion G-T56N (1.65 GHz dual core) APU
* '''AMD Fusion G-series''' AMD Fusion G-T56N (1.65 GHz dual core) APU
Line 43: Line 42:
claiming the SPI flash is 16MB. They also use red pen over the chip
claiming the SPI flash is 16MB. They also use red pen over the chip
so you wont see this deceit.
so you wont see this deceit.
=== Building a coreboot image ===
Make a fresh clone of Coreboot into a empty directory and run:
make crossgcc-i386
Make a cup of tea.. Then run:
make menuconfig
and select Jetway/NF81-t56N-LF under "Mainboard -> Mainboard vendor/model" leaving
everything else as defaults. Then finally do,
make
To flash the board with '''flashrom''' run:
flashrom -p ft2232_spi:type=2232H,port=A -c "MX25L1605A/MX25L1606E" -w build/coreboot.rom
''assuming'' you have a SPI flasher setup.


== Status ==
== Status ==
Line 222: Line 235:
with '''Die=0'''.
with '''Die=0'''.


== Building a coreboot image ==
=== Coreboot S3 suspend/resume ===
 
Make a fresh clone of Coreboot into a empty directory and run:
make crossgcc-i386
Make a cup of tea.. Then run:
make menuconfig
and select Jetway/NF81-t56N-LF under "Mainboard -> Mainboard vendor/model" leaving
everything else as defaults. Then finally do,
make
 
To flash the board with '''flashrom''' run:
flashrom -p ft2232_spi:type=2232H,port=A -c "MX25L1605A/MX25L1606E" -w build/coreboot.rom
''assuming'' you have a SPI flasher setup.
 
=== Coreboot S3 resume log ===


S3 Suspend/Resume works by running:
S3 Suspend/Resume works by running:

Revision as of 05:45, 15 April 2014