EHCI Gadget Debug: Difference between revisions

From coreboot
Jump to navigation Jump to search
Line 25: Line 25:
Remove all usb gadget drivers such as g_ehter or g_mass_storage with rmmod then do:
Remove all usb gadget drivers such as g_ehter or g_mass_storage with rmmod then do:
  modprobe g_dbgp
  modprobe g_dbgp
=== Running ===
I recommend to open the TTY before starting debug target. Doing it the other way
around slows down the debug target boot and seems to confuse serial gadget framework.
You may want to disable some CR/LF translations on the device:
stty -icrnl -inlcr -F /dev/ttyGS0
You can directly open the device node, possibly redirecting to file:
cat /dev/ttyGS0
.. or use a terminal client:
picocom -ir /dev/ttyGS0


=== Finding the USB debug port ===
=== Finding the USB debug port ===

Revision as of 18:54, 26 August 2013

Introduction

This page is about using embedded GNU/Linux devices in order to get the USB debug logs.

Howto

Patching

Download the patches that maintain TTY connected while debug target power-cycles or when host controller is reset.

Apply the patches from one of the v3.8- or v3.10-debug-gadget directories on your kernel build tree.

Compiling

  • You need to be familiar with (cross) compiling your kernel.
  • (Cross) compile it as usual but during the configuration do the following:

Go into Device Drivers:

Device Drivers  --->

Then go into USB support:

[*] USB support  --->

Then go into USB Gadget Support:

<M>   USB Gadget Support  --->

Then enable the following option:

<M>     EHCI Debug Device Gadget

Then select the serial option:

        EHCI Debug Device mode (serial)  --->

Loading

Remove all usb gadget drivers such as g_ehter or g_mass_storage with rmmod then do:

modprobe g_dbgp

Running

I recommend to open the TTY before starting debug target. Doing it the other way around slows down the debug target boot and seems to confuse serial gadget framework.

You may want to disable some CR/LF translations on the device:

stty -icrnl -inlcr -F /dev/ttyGS0

You can directly open the device node, possibly redirecting to file:

cat /dev/ttyGS0

.. or use a terminal client:

picocom -ir /dev/ttyGS0

Finding the USB debug port

See EHCI Debug Port#Finding the USB debug port

Tested hardware

Brand and Device kernel used Target devices works?
Goldelico GTA04 A3 neil-plus kernel and branch (3.7) Lenovo X60 Yes
Buglabs's bug 2.0 bug20-2.6.35-linaro's master (2.6.35) Lenovo X60 Yes