EM100pro: Difference between revisions
Jump to navigation
Jump to search
(Created page with "= Linux Utility = We are working on a Linux utility to drive the EM100Pro. Get the sources with $ git clone http://review.coreboot.org/em100 Browse the source code here: ht...") |
(No difference)
|
Revision as of 17:13, 10 September 2015
Linux Utility
We are working on a Linux utility to drive the EM100Pro. Get the sources with
$ git clone http://review.coreboot.org/em100
Browse the source code here: http://review.coreboot.org/gitweb?p=em100.git;a=summary
Here's how to use the utility:
em100: EM100pro command line utility Example: ./em100 --stop --set M25P80 -d file.bin -v --start Usage: -c|--set CHIP: select chip emulation -d|--download FILE: upload FILE into EM100pro -r|--start: em100 shall run -s|--stop: em100 shall stop -v|--verify: verify EM100 content matches the file -t|--trace: trace mode -F|--firmware-update FILE: update firmware in EM100pro (dangerous) -f|--firmware-dump FILE: export firmware in EM100pro to file -S|--set-serialno NUM: set serial number to NUM -p|--holdpin [LOW|FLOAT|INPUT]: set the hold pin state -x|--device BUS:DEV use EM100pro on USB bus/device -l|--list-devices list all connected EM100pro devices -D|--debug: print debug information. -h|--help: this help text
USB Tracing
When using VMware player to run the Windows utilities, the EM100pro will get confused by Windows trying to set the device up after Linux already did. To avoid that, add the following line to your .vmx file:
usb.quirks.device0 = "0x04b4:0x1235 skip-reset, skip-refresh, skip-setconfig"