Supported Serial Ports
SuperI/O with integrated UARTs
coreboot supports a variety of SuperI/O chips with UART functionality. If your mainboard has a serial port built-in, you can use it with no or minimal changes.
PCIe/Mini PCIe based serial cards
Experimental coreboot and libpayload support is available for the StarTech MPEX2S952 card. In order to use the card for romstage debugging, minimal setup of the PCIe bridge and the MPEX2S952 have to be added to romstage.c, otherwise the card is only available after the resource allocator has been running.
USB to Serial Converters
USB to serial converters are not supported by coreboot at this time.
Enabling Serial Console
In order to get serial console output from various components of your system special options may be needed. This page tries to give a short description of how to use these options.
In coreboot you have to set up serial console support during configuration. Enable Console--> Serial port console output. You will be able to
In your boot/grub/menu.lst add the following:
serial --unit=0 --speed=115200 terminal --timeout=15 serial console
Change --unit=0 to --unit=1 for the second serial port (COM2).
Linux kernel command line
to send debug output to both the serial console on COM1 and to VGA.
Linux login prompt
In /etc/inittab add/enable a line like this:
T0:23:respawn:/sbin/getty -L ttyS0 115200 vt100
Change ttyS0 to ttyS1 for COM2.
| I, the copyright holder of this work, hereby release it into the public domain. This applies worldwide.
In case this is not legally possible: