Talk:GIGABYTE GA-M57SLI-S4: Difference between revisions

From coreboot
Jump to navigation Jump to search
(swap ce and wp poss. ?)
 
(thf)
Line 1: Line 1:
swap #CE and #WP and thus route #CE through the #WP jumper with 8 pin SPI possible ?
swap #CE and #WP and thus route #CE through the #WP jumper with 8 pin SPI possible ?
--[[User:Quux|da Great QUUX]] 14:24, 28 April 2007 (CEST)
--[[User:Quux|da Great QUUX]] 14:24, 28 April 2007 (CEST)
----
Alternatively, you might flip a standard plcc-32 socket over the mainboard-chip. then wire a secondary plcc-32 socket to it wired 1:1 - except you connect /reset and /oe on the replacment chip, while you route the /oe from the mainboard to an NC pin on the secondary chip. Take off (hot unplug) the socket after successful boot-up to reflash the original chip. (so called "top hat flash" method, use at own risk, no successful report on GA M57 yet)
on GA M57SLI, is FWH mode used ? is it necessary to use different ID on ID-pins ?
----

Revision as of 17:32, 7 May 2007

swap #CE and #WP and thus route #CE through the #WP jumper with 8 pin SPI possible ? --da Great QUUX 14:24, 28 April 2007 (CEST)



Alternatively, you might flip a standard plcc-32 socket over the mainboard-chip. then wire a secondary plcc-32 socket to it wired 1:1 - except you connect /reset and /oe on the replacment chip, while you route the /oe from the mainboard to an NC pin on the secondary chip. Take off (hot unplug) the socket after successful boot-up to reflash the original chip. (so called "top hat flash" method, use at own risk, no successful report on GA M57 yet)

on GA M57SLI, is FWH mode used ? is it necessary to use different ID on ID-pins ?