答复: new config language.

[YhLu]

Eric,

I have added some hardcode to northbridge/amd/amdk8/coherent_ht.c.

Till now, I can not change NodeID from 7 to 1 for the second Node.

Do I need to send the coherent_ht.c to Stefan to check or after I finished
the debug?

Regards

Yinghai Lu

-----邮件原件-----
发件人: YhLu 
发送时间: 2003年6月20日 14:23
收件人: ebiederman at lnxi.com
抄送: ron minnich; linuxbios at clustermatic.org
主题: 答复: new config language.

Eric,

S2880 is 2P and it is ready.
S4880 is 4P and it is on-going.

Regards

Yinghai Lu

-----邮件原件-----
发件人: ebiederman at lnxi.com [mailto:ebiederman at lnxi.com] 
发送时间: 2003年6月20日 14:11
收件人: YhLu
抄送: ron minnich; linuxbios at clustermatic.org
主题: Re: new config language.

YhLu <YhLu at tyan.com> writes:

> Eric,
> 
> Thanks for the info about ROMCC.

Welcome.  Given that we are switching to writing all of the code before
memory is initialized knowing how stable  the main tool for doing the job
is useful.  And the list was copied so I don't have to mention it multiple
times.

> The code about mem init in northbridge/amd/amdk8/coherent_ht.c and
> northbridge/amd/amdk8/raminit.c had some overlap. On bus 0, dev 0x18 and f
> 1.

Very peculiar as I don't see that code and the actual coherent HT mapping
is just concerned with function 0.    The mapping which specifies which
resources go where is on function 1.
 
> I will add something at northbridge/amd/amdk8/coherent_ht.c

There are some peculiarities as the code is a first pass at properly 
factoring it.  I think I made a good stab at it but the code still
needs to be generalized.   

An important thing to not is that when the code is done there should
be no board specific hard codes, excpet in code that lives in auto.c

Do you have a 4P case or just 2P?

Eric
_______________________________________________
Linuxbios mailing list
Linuxbios at clustermatic.org
http://www.clustermatic.org/mailman/listinfo/linuxbios