about etherboot and mkelfImage

[rimy2000]

Thanks, but 

1. My Kernel is workable under Normal BIOS, it is even workable under Linux BIOS without Etherboot.
2. Yes, I have added them: 

./mkelfImage --kernel=/mnt/root/bzImage-17 --output=vmlinuz.vo --command-line="c
onsole=/dev/ttyS0,115200n8 root=/dev/hda2"

----- Original Message ----- 
From: "YhLu" <YhLu at tyan.com>
To: "rimy2000" <rimy2000 at hotmail.com>; <linuxbios at clustermatic.org>
Sent: Saturday, September 06, 2003 11:35 AM
Subject: Re: about etherboot and mkelfImage


1. You need to verify your Kernel is workable under Normal BIOS.
2. when you using mkelfimage, you need add parameters for Console port and
baud rate.

YH.

-----邮件原件-----
发件人: rimy2000 [mailto:rimy2000 at hotmail.com] 
发送时间: 2003年9月5日 20:24
收件人: linuxbios at clustermatic.org
主题: Re: about etherboot and mkelfImage

After I upgrade binutils to 2.14, mkelfImage 2.5 work find and the new
output is

Loading 172.27.4.23:vmlinuz.vo ...(ELF)...
............................................................................
............................................................................
............................................................................
............................................................................
............................................................................
............................................................................
............................................................................
............................................................................
.......................................................................done

rhine disable

Firmware type: LinuxBIOS

but then I received nothing from serial.

Any hint?

Thanks!

_______________________________________________
Linuxbios mailing list
Linuxbios at clustermatic.org
http://www.clustermatic.org/mailman/listinfo/linuxbios