[LinuxBIOS] [linux-usb-devel] [RFC][PATCH 0/2] x86_64 Early usb debug port support.

Eric W. Biederman ebiederm at xmission.com
Wed Dec 6 00:50:05 CET 2006


"Lu, Yinghai" <yinghai.lu at amd.com> writes:

> -----Original Message-----
> From: linuxbios-bounces at linuxbios.org
> [mailto:linuxbios-bounces at linuxbios.org] On Behalf Of
> ebiederm at xmission.com
> Sent: Tuesday, December 05, 2006 3:01 AM
>
>>+static int ehci_wait_for_port(int port)
>>+{
>>+	unsigned status;
>>+	int ret, reps;
>>+	for (reps = 0; reps >= 0; reps++) {
>>+		status = readl(&ehci_regs->status);
>>+		if (status & STS_PCD) {
>>+			ret = ehci_reset_port(port);
>>+			if (ret == 0)
>>+				return 0;
>>+		}
>>+	}
>>+	return -ENOTCONN;
>>+}
>>+
>
> What do you mean by
> +	for (reps = 0; reps >= 0; reps++) {
> ?

If you will not reps is negative.  Roughly it is a loop
that will timeout eventually if a usb debug cable is not present.
Putting some deliberate delays in there so I could be certain
of timing out after a second or two would probably be better, but
I don't have anything that resembles a good timer at that point.

The problem is you have to wait until the ehci notices your usb
debug cable before you reset it and get it going and that can be a
non-trivial amount of time.  So the loop is 100% necessary.

So since I didn't know how many loop iterations made sense I allowed
it to loop for 2^31 times or until reps goes negative.

Eric




More information about the coreboot mailing list