[LinuxBIOS] DK8-HTX Early Hang with HTX Card Intsalled
Lu, Yinghai
yinghai.lu at amd.com
Tue Dec 12 21:47:20 CET 2006
Interrupts still doesn't work?
Try cat /proc/interrupts or /var/log/messages to see if it get
interrupt.
YH
-----Original Message-----
From: linuxbios-bounces at linuxbios.org
[mailto:linuxbios-bounces at linuxbios.org] On Behalf Of
mcqmcqmcq at fastmail.fm
Sent: Tuesday, December 12, 2006 12:22 PM
To: Lu, Yinghai; linuxbios at linuxbios.org
Subject: Re: [LinuxBIOS] DK8-HTX Early Hang with HTX Card Intsalled
> You can use 2.6.19 later kernel and enable HT_IRQ in it. --- Eric
worked
> it out, and I didn't have chance to test it.
Hey, 2.6.19.1 actually boots (better than 2.6.19)! 2.6.19.1
with HT_IRQ turned on yields:
sh-3.1# modprobe ib_ipath
PCI: No IRQ known for interrupt pin C of device 0000:40:01.0. Probably
buggy MP table.
mtrr: type mismatch for fd500000,100000 old: write-back new:
write-combining
ib_ipath 0000:40:01.0: mtrr_add() WC for PIO bufs failed (-22)
ib_ipath 0000:40:01.0: infinipath0: Write combining not enabled (err
22): performance may be poor
Note that HT_IRQ removes the complaint (formerly right before
the mtrr complaints):
ipath_core 0000:40:01.0: infinipath0: irq is 0, BIOS error? Interrupts
won't work
Further fun stuff to try? I am your board monkey.
-mcq
--
mcqmcqmcq at fastmail.fm
--
http://www.fastmail.fm - Same, same, but different...
--
linuxbios mailing list
linuxbios at linuxbios.org
http://www.openbios.org/mailman/listinfo/linuxbios
More information about the coreboot
mailing list