[LinuxBIOS] Tyan s2892 the OLPC way
Lu, Yinghai
yinghai.lu at amd.com
Fri Oct 13 20:05:13 CEST 2006
You need to enable smp in the kernel to get apic enabled. And use
maxcpus=1 if you only need one cpu running.
YH
-----Original Message-----
From: linuxbios-bounces at linuxbios.org
[mailto:linuxbios-bounces at linuxbios.org] On Behalf Of Myles Watson
Sent: Friday, October 13, 2006 10:53 AM
To: 'Richard Smith'
Cc: linuxbios at linuxbios.org
Subject: Re: [LinuxBIOS] Tyan s2892 the OLPC way
>> I can't mount my IDE hard drive, even though I can see it in the
/proc
>> filesystem. I'm trying mount -t ext3 /dev/hda1 /hdd.
>>
>/dev/hda[?] don't exist in the simple filesystem. Did you add the
>devices to devices.txt?
Yes I did. I wasn't sure if I added them correctly, though. I just
copied
most of the entries from another line and changed the major and minor
numbers.
>> When I do an lspci, all the IRQs are routed to IRQ 0. I don't know
if
>> this is the root of the problem, or a symptom.
>That's a bad thing. Your interrutps are not routed correctly. That's
>LinuxBIOS and not buildrom though.
It works for a different kernel through the filo etherboot pathway, so
I'm
wondering if I've misconfigured the kernel. Do I need to explicitly
support
the Opteron? I'm using a 32-bit kernel because there are no linux-tiny
patches for 64-bit.
Myles
--
linuxbios mailing list
linuxbios at linuxbios.org
http://www.openbios.org/mailman/listinfo/linuxbios
More information about the coreboot
mailing list