[LinuxBIOS] Flashing with flashrom ok but no debug on com port

[ccases at navista.fr]

> * ccases at navista.fr <ccases at navista.fr> [070322 11:20]:
>> Hi all,
>>
>> I have successfully flash LinuxBIOS on my chip SST39SF020A with
>> flashrom,
>> when I reboot my card, I have no visual response, after that I use an
>> Null
>> modem db9 wire between my card with LinuxBios et my computer. I have use
>> Hyperterminal with parameter 115200 baud, 8bit, no parity, 1 bit stop,
>> and
>> after reboot my card, I have nothing ...
>>
>> I don't know why, in my config file I have set normally the good line
>> for
>> active the com port in debug mode, but if somebody know all of the
>> modification for check if it's ok, it's welcome ;).
>>
>> thanks by advance for your help.
>>
>> regards
>>
>> Ccases
>>
>> PS : my card is an advantech pcm-5823
>
> It's a geode gx1?
>

Yes

> This looks like you did not initialize the SuperIO correctly.
>
> What SuperIO do you have on the board?
>

It's an Winbond W83977AF-F and I use the W83977TF on LinuxBios.

thanks for your help

regards

Ccases