[LinuxBIOS] VIA Auto Power ON
Corey Osgood
corey_osgood at verizon.net
Thu May 3 00:28:14 CEST 2007
Peter Stuge wrote:
> On Wed, May 02, 2007 at 08:01:14AM +0200, Marcel Graber wrote:
>> Is there a solution to get the via epia-m2 board to auto Power
>
> There's a simple way to do it in hardware at least, put a capacitor
> over the PWRSW pins.
>
> I've gotten the most reliable results with a 1uF electrolytic
> capacitor, higher capacitances have been unreliable.
>
> (Note the polarity if you're using an electrolytic capacitor.)
>
>
> //Peter
>
Looking at the vt8237r datasheet, for offset 82 of device 17, bus
control/power management device:
4 SUSC# AC-Power-On Default Value .................RO
This bit is written at RTC Index 0D bit-7. If this bit
is 0, the system is configured to “default on” when
power is connected.
So a good place to start would be the vt8235 datahseets.
-Corey
More information about the coreboot
mailing list