[coreboot] Stepping in boot code of DB800 via JTAG
Marc Jones
Marc.Jones at amd.com
Tue Apr 22 18:11:42 CEST 2008
llandre wrote:
> I successfully booted the DB800 evaluation board with coreboot v2,
> however I can't step the boot code via JTAG (FS2 System Navigator).
> Following is the console dump.
> Anybody experienced the same problem?
llandre,
I think you need to halt before you step. On a reset the CPU runs unless
you put it into debug stall via the bootstrap options. See
GLCP_SYS_RSTPLL 4C000014h.
Marc
--
Marc Jones
Senior Firmware Engineer
(970) 226-9684 Office
mailto:Marc.Jones at amd.com
http://www.amd.com/embeddedprocessors
More information about the coreboot
mailing list