[coreboot] [PATCH] Fix SB600 SATA and add support for port 2-4

[Carl-Daniel Hailfinger]

Hi Zheng,

On 23.12.2008 03:26, Bao, Zheng wrote:
> Reviewed-by: zheng bao <zheng.bao at amd.com>
>
> It is tested well on dbm690t and pistachio.
>   

Thank you for the fast review!

Our commit process is a bit difficult because it needs an Acked-by:
statement. (The subversion repository will reject a commit without
Acked-by.)

Everybody who understands the code is allowed to ack a patch. You
understand that piece of code very well, so could you please also add an
Acked-by statement? Thanks!

Regards,
Carl-Daniel

> -----Original Message-----
> From: Carl-Daniel Hailfinger [mailto:c-d.hailfinger.devel.2006 at gmx.net] 
> Sent: Tuesday, December 23, 2008 10:01 AM
> To: Coreboot
> Cc: Bao, Zheng
> Subject: [PATCH] Fix SB600 SATA and add support for port 2-4
>
> The SB600 RPR documentation does not mention what to do if SATA_BAR0+6
> is no longer 0xA0 or 0xB0. It simply assumes that will never happen.
> My 500 GB Seagate Barracuda ST3500820AS triggers that corner case on the
> first init after poweron.
> The current code hangs forever with my drive. Fix this by rerunning the
> init sequence after SATA_BAR0+6 is no longer 0xA0 or 0xB0.
>
> Add support for SATA port 2-4 (Primary Slave, Secondary Master,
> Secondary Slave).
>
> Activate and improve debug messages for SPEW log level.
>
> Fix some comments.
>
> New log messages look like this:
> PCI: 00:12.0 init
> sata_bar0=3020
> sata_bar1=3060
> sata_bar2=3030
> sata_bar3=3070
> sata_bar4=3000
> sata_bar5=fc309000
> SATA port 0 status = 23
> 0x6=a0, 0x7=80
> drive detection not yet completed, waiting...
> 0x6=a0, 0x7=80
> drive detection not yet completed, waiting...
> [... 281 repetitions ...]
> 0x6=0, 0x7=50
> drive no longer selected after 2830 ms, retrying init
> drive detection done after 10 ms
> Primary Master device is ready
> SATA port 1 status = 23
> drive detection done after 10 ms
> Primary Slave device is ready
> SATA port 2 status = 0
> No Secondary Master SATA drive on Slot2
> SATA port 3 status = 0
> No Secondary Slave SATA drive on Slot3
>
> Full log is attached.
>
> With this patch (and my other non-SATA fixups), my Asus M2A-VM boots
> into Linux without problems.
>
> Signed-off-by: Carl-Daniel Hailfinger
> <c-d.hailfinger.devel.2006 at gmx.net>
>
>   

-- 
http://www.hailfinger.org/