[coreboot] [LinuxBIOS] abit be6

[Sergei Antonov]

On Jan 13, 2008 10:08 PM, Jouni Mettälä <jtmettala at gmail.com> wrote:
>
>
>
> On Jan 12, 2008 7:24 PM, Peter Stuge <peter at stuge.se> wrote:
> >
> > On Sat, Jan 12, 2008 at 02:15:34PM +0200, Jouni Mettälä wrote:
> > > LinuxBios booted to filo. Motherboard is abit be6. This is azza/pt-6ibd/
> > > config using http://coreboot.org/AZZA_PT-6IBD_Build_Tutorial. filo
> > > config was also from it.
> >
> > Cool!
> >
> > FILO doesn't find a hard drive at hda. Do you have one there?
> >
> > Either way, it would be nice if you could use memtest as payload and
> > let it run for a few hours to check that RAM is set up right.
> >
> >
> > //Peter
> >
>
>  It now boots with filo. This time with different filo Config file. # means
> these lines were commented out.
>
> #USE_GRUB = 1
> MENULST_TIMEOUT = 6 -> = 10
> VGA_CONSOLE = 1 -> VGA_CONSOLE = 0
> PC_KEYBOARD = 1 -> PC_KEYBOARD = 0
> #SUPPORT_PCI = 1
> #PCI_BRUTE_SCAN = 1
> added
> DEBUG_ALL = 1
>
> using single 64M chip memtest was ok after 20 minutes. If longer time is
> needed then I test new version of memtest. Reading supported motherboards
> azza/pt-6ibd/ works also with 64MB it is marked as WIP.
>
> Keyboard isn't working yet. Tested ps/2 keyboard. Using kernel as boot file
> it boots. I can't log in with keyboard  or minicom. This could be something
> simple I don't now. Writing of boot line works with minicom.

I can confirm. It has been reported by me a while ago:
http://www.coreboot.org/pipermail/coreboot/2007-December/028256.html
People on IRC tried to help me, but the problem still remains.

Did you use flashrom on this board? It didn't work for me, and I had
to use uniflash in dos.