[coreboot] Firmware hub flash addressing [off-topic]
llandre
r&d2 at dave-tech.it
Wed Jun 11 11:34:35 CEST 2008
Sorry for posting a message that is a little bit off-topic.
I'm working with a SST 8 Mbit Firmware Hub SST49LF008A flash connected
to Geode LX LPC bus.
I need to understand where flash registers are mapped in case the flash
ID is set to 1 (this flash is not the boot flash that has ID=0).
The datasheet just says about identification registers (same thing
applies for other registers too):
JEDEC ID Registers
The JEDEC ID registers for the boot device appear at
FFBC0000H and FFBC0001H in the 4 GByte system
memory map, and will appear ***elsewhere*** if the device is not
the boot device.
Anybody can tell me what does "elsewhere" stand for in this sentence?
TIA,
llandre
DAVE Electronics System House - R&D Department
web: http://www.dave.eu
email: r&d2 at dave-tech.it
More information about the coreboot
mailing list