[coreboot] r3529 - trunk/coreboot-v2/targets/tyan/s2912_fam10

[Marc Jones]

Arne Georg Gleditsch wrote:
> Marc Jones <Marc.Jones at amd.com> writes:
>   
>> Arne Georg Gleditsch wrote:
>>     
>>> Marc Jones <Marc.Jones at amd.com> writes:
>>>       
>>>> This was my fault. I missed reviewing the abuild config.
>>>>
>>>> This is now the same as serengeti_cheetah_fam10.
>>>>
>>>> A little background information. The fam10 initialization is a bit
>>>> larger than the K8 code. To make more room in the same 512K ROM that
>>>> most platforms have the normal image was dropped. The other change is
>>>> the use of failover. This makes the XIP CAR code live in only one
>>>> place instead of in the fallback and normal images.
>>>>
>>>> Arne, please test a s2912_fam10 abuild and ack this.
>>>>         
>>> I'll do so.  However, once I start digging into this -- would it make
>>> sense to fix it properly so that the target builds a full 1024K ROM (as
>>> the board is equipped with) and actually includes both the normal and
>>> failover image?
>>>
>>>       
>> Sure, That would be great.
>>     
>
> Sorry about the delay, I was sidetracked by other stuff.  Here's a patch
> towards r3690 upping the ROM size for the S2912 Fam10 target to 1M.
> Both regular and abuild images have been boot tested successfully.  (Not
> having a proper abuild infrastructure set up, the abuild image fails on
> not having a real payload available, but otherwise looks correct.)
>
> Signed-off-by: Arne Georg Gleditsch <arne.gleditsch at numascale.com>
>
>   
I added cross-compile to the Config-abuild.lb so it will work for me in 
with Ubuntu.

Acked-by: Marc Jones <marc.jones at amd.com>

r3711

-- 
Marc Jones
Senior Firmware Engineer
(970) 226-9684 Office
mailto:Marc.Jones at amd.com
http://www.amd.com/embeddedprocessors