[coreboot] Indtast Bcc Indtast Bcc Indtast Bcc Indtast Bcc Wyse S10 and coreboot

anders@jenbo.dk anders at jenbo.dk
Fri May 21 13:45:17 CEST 2010


I haven't worked with build in gratis cards, but you will probably need a copy of your vga Rom. I prefer to have seabios load the vga Rom.

Mvh Anders

----- Reply message -----
Fra: "Oliver Schinagl" <oliver at schinagl.nl>
Dato: fre., maj 21, 2010 08:36
Emne: [coreboot] Indtast Bcc Indtast Bcc Indtast Bcc Wyse S10 and coreboot
Til: <coreboot at coreboot.org>

On 05/21/2010 08:28 AM, anders at jenbo.dk wrote:
> You will need the developer package of pciutils, use the name on the 
> wiki it is in the ubuntu repository.
I couldn't find it, well unless it's pciutils and pci-utils-dev :p I'll 
search more.
>
> Yes seabios is the best to start of with, download it via git, and 
> configure it as a payload (se wiki) then make it.
All right.
>
> For coreboot al you need to do is pick s50 as the board, pick the 
> right Rom size, point to the payload.
The romsize defaults to 256k but according to flashrom (And the markings 
on the chip) it's a 2mb flash unit?
Also there's a lot of VGA, VSA and other settings that where very 
confusing as I read somewhere on the wiki; that the Geode GX2/LX don't 
support VGA things? And the VSA bit, I found that there is OpenVSA but 
it's highly experimental? Do I need it at all?
> As for network boot you will need an additional tool (look at the wiki).
GPXE stuff I belive?


Thank you for your time so far!

Oliver

-- 
coreboot mailing list: coreboot at coreboot.org
http://www.coreboot.org/mailman/listinfo/coreboot
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.coreboot.org/pipermail/coreboot/attachments/20100521/904729dd/attachment.html>


More information about the coreboot mailing list