[LinuxBIOS] Via Epia ML5000, LinuxBios, Filo -- 99 % there, need help with last 1%!
eric at zyxod.com
Tue Apr 18 07:37:26 CEST 2006
I've gotten LinuxBIOS working without much of a hitch, but I'm trying to
get the VGA console working. I've been looking through the email
archives without much success, then I found this page:
I have a Via Epia ML5000 board. My question is specific to this part,
found at the above URL:
/If you want to use the onboard VGA chip, you have to do the following
in additional to the CONFIG options described above. /
/1. in MB Config.lb You need to specify for your onboard VGA /
/device pci 9.0 on # PCI
/ chip drivers/pci/onboard
device pci 9.0 on end
register "rom_address" = "0xfff80000" #512k image
#register "rom_address" = "0xfff00000" #1M image
Is PCI 9.0 the correct value for the Via Epia-M onboard CLE266 video?
Is there a way to find out, such as lspci?
What about the "rom_address" field -- Can someone explain what this is,
and how to set it properly?
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the coreboot