Search results

** Find a way to disable or crash the ME would probably have no effect at all on flash protections ...

* all parameters are pushed onto the stack * all other parameters are pushed onto the stack ...

|PCI_cards_comments = All 6 PCI slots tested successfully using a PCI graphics card. ...

...lel port, the serial ports (COM1 + COM2), and the keyboard should work for all chips. More advanced stuff may need more work, though.<br /> ¹⁸ Partially supported, but not all features implemented.<br /> ...

...the distribution's kernel source code package there is no need to compile all the other modules and initramfs/uImage/uInitrd/vmlinuz. Remove all usb gadget drivers such as g_ether or g_mass_storage with ''rmmod'' or ''mo ...

* All variables are assigned before use * All objects should have fully qualified types (''unsigned int'' instead of ''un ...

...t affected by whether or not coreboot was built with "Build for ChromeOS". All these modules are in mainline, so they should be available with any recent The EC allows dimming the display backlight all the way to 0. If the backlight is accidentally set to 0, and the screen is ...

<!-- <br clear="all" /> --> |PCI_cards_comments = Tested: PCI NIC (in all slots); graphics card. ...

...n - do we need to set up registers, put in tables, kick things, or will it all Just Work (TM)? ...wn laptops. The exceptions are Asus and Apple, and even Apple doesn't make all of their laptops. ...

|PCI_cards_comments = Tested: PCI NE2000 compatible ethernet card in all slots. ...

...er PCI configuration and BAR address space are used for all communication. All three transfer types are supported (OUT/SETUP/IN) but transfers can only be ...User:Uwe|Uwe Hermann]]. Any physical USB port will work, as the code tries all ports until the one with the attached USB Debug device is found. ...

* USB (all 3 ports) + ports on a docking station All T430s I saw so far come with WSON-8 flash package, though apparently some p ...

...PCI bus. So activate a higher level of debug output in coreboot to collect all information you need here. Ignore the black lines in the picture. They may * "ping" the network card and check if its interrupt count increases. Check all the other PCI devices in your system and let them generate interrupts. Alwa ...

{{Warning|Remove all batteries and unplug the power connector. You have to make sure to supply e Remove all regions that are disabled or invalid as flashrom can't ignore them, here: ...

...later in order to add the socket in the correct orientation. The ROM chips all have a marking where the top is (and the same is true for most boards), but ...te corners of the socket first, in order to fixate the socket. Then solder all the other pins, one after the other. If you apply too much solder and two o ...

All regions are re-writeable with an external SPI flasher, and the descriptor c First of all make a backup with your external programmer and verify it be a proper image ...

'''Note:''' Micron lists SPD values for all the memory they produce. This really helps when trying to trouble shoot mem ...

[[Media:Coreboot_logo_kit.zip|Coreboot_logo_kit.zip]] contains all files on this page in a convenient archive. ...

...eased in 2009 (ASUS). It is well supported and stable under Coreboot, with all CPUs, RAM, and peripherals functioning normally. Family 10h (61xx) processo ...e PCIe lane widths for the gigabit network controller, which are both x1. All legacy PCI devices share the same bus, and partially due to this design the ...

|PCI_cards_comments = Tested: NIC and/or VGA PCI card in all 4 PCI slots (console + X11 work fine). ...